Please follow the instructions on this sheet when charging the battery. Be sure to recharge after each use.

1. Plug the charger into a standard 110 volt wall outlet. If you’re using a Vexilar Ultra Pack, be sure the Master Power Switch is in the ON position. The GREEN light will come on. You do not need to disconnect the flasher unit.
   
   
2. Connect the red clip to the positive battery terminal, or charging post, and the black clip to the negative terminal, or charging post. The GREEN light will go out and the RED light will come on.
   
   
3. Allow the battery to charge until the GREEN light comes back on.
   

This charger is a fully automatic three-stage, 1 Amp, charger. It will recharge a completely discharged 9 amp battery in 8 hours or less. When the light turns GREEN, it indicates the charger has switched to Maintenance Mode The battery voltage will be maintained at a safe level indefinitely. battery’s next use.